CNC.xyz

Posted: **Tue Feb 18, 2014 4:51 pm**

Thanks, according to http://www.newark.com/pdfs/techarticles ... sBrchr.pdf (Tip #5) it seems that a direct connect is ok as long as the CNC Controller uses TTL and not CMOS logic. (I'll check which one you have once your wiki page start working again, apparently it is not working today)

I'll blame curiosity if I break anything

Posted: **Tue Feb 18, 2014 10:54 pm**

Fixed the wiki page.

The chip can run from 3v to 5.5v.

Due is most likely TTL, and Unos are closer to CMOS levels.

The driver chip should be able to handle either.

CNC.xyz

Using an Arduino Due to control the electronics

Re: Using an Arduino Due to control the electronics

Re: Using an Arduino Due to control the electronics